Raytheon Raychart 601 connected to A R41 XX radar

Thanks for the reply

I will check this

How-ever...

I have another unit (601 chart) and I connected it for trouble
shooting purposes, and its doing the same thing


On Thu, 23 Jun 2005 18:58:12 GMT, "Doug"
wrote:

>
>"Big gus" wrote in message
>
>> Hi all
>>
>> I have this issue
>> I have done a hard reset on both units
>>
>> The Raychart puts the chart on the radar screen ok but after about 30
>> seconds, the chart plotting seems to lock up. With the exception of ,
>> you can still move the cross-hairs and only the cross hairs. no other
>> button on the 601 does anything except the power button
>>
>> If you power off and then back on the 601, it will work fine for abut
>> 30 more seconds.
>>
>> ANy thoughts?
>>
>> Thanks
>> Mark
>
>The Raychart 600 series usually had a nicad battery on a small daughter PCB.
>These batteries go bad and leak, eventually getting onto the main circuit
>board. I would remove the case and inspect for battery damage...carefully
>clean it up and inspect for circuit traces etched open by the battery goop.
>If you are lucky, a cleaning and replacement of the entire daughter assembly
>with fresh battery will fix it. The assemblies run around $ 20 from
>Raymarine. They are solder in assemblies, so if not qualified, get it to a
>service shop. Wash hands thoroughly after you are done as this stuff contain
>cadmium, a poison.
>
>Doug K7ABX
>>
>
 >> Stay informed about: Raytheon Raychart 601 connected to A R41 XX radar 

Big gus wrote in


> The Raychart puts the chart on the radar screen ok but after about 30
> seconds, the chart plotting seems to lock up. With the exception of ,
> you can still move the cross-hairs and only the cross hairs. no other
> button on the 601 does anything except the power button
>
>

When I returned the 2nd corroded-up Raymarine radome to them for "repair",
I also included the RL70CRC color chart plotter/radar display unit with it.
Raymarine found one hardware fault in it and lots of upgraded firmware to
put in it from all the firmware program corrections and bug fixes
discovered.

Might not be a bad idea to give Raymarine a call with that model and serial
number in your hand so they can look to see if you need a firmware upgrade
or hardware repair. Their upgrade on ours fixed a niggling problem we had
trying to get the screen to point up to match the boat's course correctly.
It also had an error in the Seatalk communications. Our Raymarine compass
sensor now calibrates properly and the Smart Heading Sensor gyro-compass
unit now gives proper input to the RL70CRC display.

I think you have a firmware fault that needs fixing.

--
Larry

You know you've had a rough night when you wake up and you're outlined in
chalk.
 >> Stay informed about: Raytheon Raychart 601 connected to A R41 XX radar 

"Larry W4CSC" wrote in message

> Big gus wrote in
>
>
> > The Raychart puts the chart on the radar screen ok but after about 30
> > seconds, the chart plotting seems to lock up. With the exception of ,
> > you can still move the cross-hairs and only the cross hairs. no other
> > button on the 601 does anything except the power button
> >
> >
>
> When I returned the 2nd corroded-up Raymarine radome to them for "repair",
> I also included the RL70CRC color chart plotter/radar display unit with
it.
> Raymarine found one hardware fault in it and lots of upgraded firmware to
> put in it from all the firmware program corrections and bug fixes
> discovered.
>
> Might not be a bad idea to give Raymarine a call with that model and
serial
> number in your hand so they can look to see if you need a firmware upgrade
> or hardware repair. Their upgrade on ours fixed a niggling problem we had
> trying to get the screen to point up to match the boat's course correctly.
> It also had an error in the Seatalk communications. Our Raymarine compass
> sensor now calibrates properly and the Smart Heading Sensor gyro-compass
> unit now gives proper input to the RL70CRC display.
>
> I think you have a firmware fault that needs fixing.
>
> --
> Larry
>
> You know you've had a rough night when you wake up and you're outlined in
> chalk.
>
Larry, The 601 and R41 were Raytheon products, not Raymarine. The R41XX was
actually OEMed by JRC.
You are mixing apples and oranges trying to compare it with Raymarine stuff.
Incidentally Raymarine doesn't support the 600 series anymore. Have had to
trash 3 of them this month.
73
Doug K7ABX
 >> Stay informed about: Raytheon Raychart 601 connected to A R41 XX radar 

"Doug" wrote in


> Larry, The 601 and R41 were Raytheon products, not Raymarine. The
> R41XX was actually OEMed by JRC.
> You are mixing apples and oranges trying to compare it with Raymarine
> stuff. Incidentally Raymarine doesn't support the 600 series anymore.
> Have had to trash 3 of them this month.
> 73
> Doug K7ABX
>
>

Oh, sorry. I didn't know it was that old. No, they won't support anything
old....neither will keyboard companies, any more.

--
Larry

You know you've had a rough night when you wake up and you're outlined in
chalk.
 >> Stay informed about: Raytheon Raychart 601 connected to A R41 XX radar